Unimark EC3000 Series Instrukcja Operatora Pobierz pdf (Strona 9)

Page 9 of 24 71U-1409-300K; REV 20 EC3000 Installation and Operator’s Manual

6.0 Bar Code Reading Operation

6.1 Bar Code Coupon Reading Using the Counter Top Version

The integrated bar code scan engine target area is located near the center of the main case top surface.

A coupon present (or detection) beam is located just in front of this target area. When a coupon cuts this beam, the scan

engine is automatically triggered to look for (or scan for) any bar codes that come into the target area.

The Unit provides an audible indication when bar code data is “transmitted” to the host system. The audible indication

does not indicate that the passenger data is valid for the specific flight, but only that the bar code presented was accurately

“scanned and transmitted”.

The AEA CB, CC, and CE (or equivalent non-AEA protocol) commands are used to generate audible and visible

indications of “Ok to Board” or “Do Not Board” conditions (same as regular magnetic data reading).

The 2D bar code scanner (or scan engine) does not have any laser components. The scan engine uses light

emitting diodes (LEDs) that create aimer lines, illumination sources, or target patterns if applicable

Although the operator is exposed to these light sources, testing has been done to demonstrate that the scan

engine is safe for this type of application (under normal usage conditions).

Just as any light source, the operator should never stare directly into the beam or lens.

Indicator showing GREEN for “OK to Board” condition

Coupon present/detection beam

Passenger (PAX) Display

Indicator showing RED for “Do Not Board” condition

Lines show approximate projected scan location for bar

code placement

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Brak uwag

Unimark EC3000 Series Instrukcja Operatora Strona 9